[dpdk-dev,v3,2/2] config: enable vector driver by default
Commit Message
Previously, vector driver is not the first (default) choice for i40e,
as it cannot fill packet type info for l3fwd to work well. Now there
is an option for l3fwd to analysis packet type softly. So enable it
by default.
Signed-off-by: Jianfeng Tan <jianfeng.tan@intel.com>
---
config/common_base | 2 +-
doc/guides/rel_notes/release_16_04.rst | 5 +++++
2 files changed, 6 insertions(+), 1 deletion(-)
@@ -169,7 +169,7 @@ CONFIG_RTE_LIBRTE_I40E_DEBUG_TX=n
CONFIG_RTE_LIBRTE_I40E_DEBUG_TX_FREE=n
CONFIG_RTE_LIBRTE_I40E_DEBUG_DRIVER=n
CONFIG_RTE_LIBRTE_I40E_RX_ALLOW_BULK_ALLOC=y
-CONFIG_RTE_LIBRTE_I40E_INC_VECTOR=n
+CONFIG_RTE_LIBRTE_I40E_INC_VECTOR=y
CONFIG_RTE_LIBRTE_I40E_RX_OLFLAGS_ENABLE=y
CONFIG_RTE_LIBRTE_I40E_16BYTE_RX_DESC=n
CONFIG_RTE_LIBRTE_I40E_QUEUE_NUM_PER_PF=64
@@ -115,6 +115,11 @@ Drivers
This made impossible the creation of more than one aesni_mb device
from command line.
+* **i40e: enable vector driver by default.**
+
+ Previously, vector driver is disabled by default as it cannot fill packet type
+ info for l3fwd to work well. Now there is an option for l3fwd to analysis packet
+ type softly, so enable vector driver by default.
Libraries
~~~~~~~~~